PL2303TA USB to Serial UART (SSOP-28) – SMD

LKR270.00LKR294.00 (-8%)

Out of stock

USB to Serial Bridge Controller

Compare

PL2303TA provides a convenient solution for connecting an RS232-like full-duplex asynchronous serial device to any Universal Serial Bus (USB) capable host. PL2303TA highly compatible drivers could simulate the traditional COM port on most operating systems allowing the existing applications based on COM port to easily migrate and be made USB ready without having to rewrite the COM port software application.

By taking advantage of USB bulk transfer mode, large data buffers, and automatic flow control, PL2303TA is capable of achieving higher throughput compared to traditional UART (Universal Asynchronous Receiver Transmitter) ports. When real RS232 signaling is not required, a baud rate higher than 115200 bps could be used for even higher performance. The flexible baud rate generator of PL2303TA could be programmed to generate any rate between 75 bps and 6M bps.

PL2303TA is exclusively designed for mobile and embedded solutions in mind, providing a small footprint that could easily fit into any connectors and handheld devices. With very small power consumption in either operating or suspend mode, PL2303TA is perfect for bus-powered operation with plenty of power left for the attached devices. Flexible signal level requirement on the RS232-like serial port side also allows PL2303TA to connect directly to any 3.3V~1.8V range devices.

Additional information

Package

Features Description

  • Fully Compliant with USB Specification v2.0 (Full-Speed)
  • On-chip USB 1.1 transceiver, 5V to 3.3V regulator, and 12 MHz crystal oscillator
  • Supports RS-232 like serial interface
    • Full-duplex transmitter and receiver (TXD and RXD)
    • Six MODEM control pins (RTS, CTS, DTR, DSR, DCD, and RI)
    • Parity error, frame error, and serial break detection
    • Programmable baud rate from 75 bps to 6,000,000 bps
  • An extensive flow control mechanism
    • Adjustable high/low watermark level
    • Automatic flow control with CTS/RTS/ XON/XOFF
  • Configurable 256-byte outbound buffer and 256-byte inbound buffer or 128-byte outbound buffer and 384-byte inbound buffer
  • Supports remote wake-up from MODEM input signals
  • Two general-purpose I/O (GPIO) pins
  • Optional external EEPROM for startup device configurations
  • Small footprint 28-pin SSOP IC package
  • Pin compatible with PL-2303HXA and PL-2303XA

See It Styled On Instagram

    No access token

Main Menu

PL2303TA USB to Serial UART (SSOP-28) - SMD

LKR270.00LKR294.00 (-8%)